Hi
I am aware of the various threads on the Mezmerize, but I cannot find what amounts to a basic instruction on the build. There are a few unexplained holes on the board and some ambiguity regarding 68 ohm resistors being doubled as examples of issues I have not been able to solve.
A conventional build set of instructions would help me greatly
Wayne
I am aware of the various threads on the Mezmerize, but I cannot find what amounts to a basic instruction on the build. There are a few unexplained holes on the board and some ambiguity regarding 68 ohm resistors being doubled as examples of issues I have not been able to solve.
A conventional build set of instructions would help me greatly
Wayne
Hello,
check out these:
http://www.diyaudio.com/forums/blogs/tea-bag/296-salas-hot-rod-dcb1.html#comment2818
DC-Coupled B1 Buffer Build
Salas HOT ROD DCB1
they should explain the build.. i built mine based on them plus the treads here at DiyA.
Read them all..then read them again.. 🙂
Good luck
check out these:
http://www.diyaudio.com/forums/blogs/tea-bag/296-salas-hot-rod-dcb1.html#comment2818
DC-Coupled B1 Buffer Build
Salas HOT ROD DCB1
they should explain the build.. i built mine based on them plus the treads here at DiyA.
Read them all..then read them again.. 🙂
Good luck
- Status
- Not open for further replies.