Hi all,
My Infocus LP350 just died, won't power up. I may have switched it off without waiting for standby to activate? I don't know, I just remember pressing standby and coming downstairs, then when I went to switch it on it was dead.
I have managed to uninstall it, and open the case, there are four little white square items (around 6mm+4mm) on the PSU main board, marked *ET1102 116UTK27 I think (very small writing). One of these seems to have popped open, as I found the top part in two pieces within the case.
Does this give any idea as to what may be at fault?, is it worth repairing, do repairs to old kit like this cost much, should I cut my losses?
Bulb was in very good condition no where near the end of it's life, with a not very old M1 DA digital cable of around 4m. 🙁
My Infocus LP350 just died, won't power up. I may have switched it off without waiting for standby to activate? I don't know, I just remember pressing standby and coming downstairs, then when I went to switch it on it was dead.
I have managed to uninstall it, and open the case, there are four little white square items (around 6mm+4mm) on the PSU main board, marked *ET1102 116UTK27 I think (very small writing). One of these seems to have popped open, as I found the top part in two pieces within the case.
Does this give any idea as to what may be at fault?, is it worth repairing, do repairs to old kit like this cost much, should I cut my losses?
Bulb was in very good condition no where near the end of it's life, with a not very old M1 DA digital cable of around 4m. 🙁
- Status
- Not open for further replies.