I/V resistor with Broskie unballancer?

[Ryssen]

I´m planning on using a Buffalo III SE with a Broskie Unballancer with 12AT7 input tubes and 6cg7 output.
But what I/V resistor should I use? To get about 2volts out.

 

[Ryssen]

What values have you others who built with the unballancer used?
I mean with other tubes so I know where to start...

 

[dahlberg]

~40-50 ohm would be a good place to start.

You have PM

 

[nautibuoy]

http://www.diyaudio.com/forums/digi...assware-unbalancer-i-v-stage.html#post4039117

The Unbalancer (near the bottom)

Ray

 

[Ryssen]

Thanks!