Hi Everyone
I am a DIY audio enthusiast. I have built a few projects including Pass 35A, Leech Double Barrelled amp, 500 mosfet power amp, Curcio pre-amp, Decware House wrecker 7th order bandpass sub (2 x 15" Peavey Blackwidow drivers). Also, I collect vintage tube amps (cause I like them - not to buy & sell for profit!).
P
I am a DIY audio enthusiast. I have built a few projects including Pass 35A, Leech Double Barrelled amp, 500 mosfet power amp, Curcio pre-amp, Decware House wrecker 7th order bandpass sub (2 x 15" Peavey Blackwidow drivers). Also, I collect vintage tube amps (cause I like them - not to buy & sell for profit!).
P
Hi P,
Welcome to the forum from across the Detroit River. Hope you find the forum enjoyable.
P.S. SW Ontario is the only place in Canada where you can travel north to reach the US.
Welcome to the forum from across the Detroit River. Hope you find the forum enjoyable.
P.S. SW Ontario is the only place in Canada where you can travel north to reach the US.
Hi there: The Decware site shows a 20x20x49.5-inch sub tower. One exploded view shows an rectangular opening (estimated 6x15-inches) in one side. Is this a temporary driver access or a port in the mid chamber. Other views do not show any evidence of the opening, hence driver(s) must have been installed from the top and/or bottom and the box sealed. Any comments would be welcome. ...regards, Michael
Hmm...I wonder if the people in BC would agree with this? (yes I realize this is a very old thread.)
- Status
- Not open for further replies.