Well I just got a job offer and have to move. In addition I have a nice working XGA projector so its time to sell my extra stuff.
1) I have a proxima DP5100 3 panel lcd projector (640*480 res...high contrast ratio)....no working bulb....I tried to put a larger bulb in, but without a reflector its pointless......it has a 250W ballast so the HQI route mght work for 35$ plus a reflector.......best offer.
2) I have an Infocus Lightpro 220 that is missing its lens and bulb......this one has an SVGA panel inside that you could potentially use to create a DIY projector smaller than the 15" ones we see on the board (the panel is 8 inches i believe).......best offer
3) I have a viewsonic that doesnt power up....Viewsonic PJ800 no bulb, but no clue whats going on with it....its a 3 panel lcd pj with XGA resolution....best offer
4) Last I have a compaq TFT 450 14" lcd monitor XGA resolution with a bad backlight....maybee you can dissasemble it and put it on the stage of an OHP.....best offer
I'm moving 1000 miles soon and need to clear my extra projector parts out so here's a good opportunity to get that toy to tinker with.
Eric
1) I have a proxima DP5100 3 panel lcd projector (640*480 res...high contrast ratio)....no working bulb....I tried to put a larger bulb in, but without a reflector its pointless......it has a 250W ballast so the HQI route mght work for 35$ plus a reflector.......best offer.
2) I have an Infocus Lightpro 220 that is missing its lens and bulb......this one has an SVGA panel inside that you could potentially use to create a DIY projector smaller than the 15" ones we see on the board (the panel is 8 inches i believe).......best offer
3) I have a viewsonic that doesnt power up....Viewsonic PJ800 no bulb, but no clue whats going on with it....its a 3 panel lcd pj with XGA resolution....best offer
4) Last I have a compaq TFT 450 14" lcd monitor XGA resolution with a bad backlight....maybee you can dissasemble it and put it on the stage of an OHP.....best offer
I'm moving 1000 miles soon and need to clear my extra projector parts out so here's a good opportunity to get that toy to tinker with.
Eric
interested in the 14" lcd monitor XGA, does the actual panel still work? and would it be hard to dismantle?
Panel works...but the backlight is toast....very very dim (shine a light onto it and you see the LCD display. As far as dissasembly...theres some screws, but i'm not too sure of my skills to take one apart (although it can't be that bad).
- Status
- Not open for further replies.