$100 with free shipping
4 x tg9 (copper cap) wired in series/parallel.
3/4" bb ply sides, top/bottom, back
1/4" front
1 : 1.618 ratios
6" deep x 9" wide x 15" tall
Acousta stuff inside
Rolls fast at 200hz.
If used for music, you will need a woofer, not a subwoofer.
Amazing intelligibility for late night listening to movies.
Think picking up on pink floyd division bell lyrics without focusing on them, it's that good.
I recommend baffle step circuit of 1.7mH + 2.5 ohms
For an extra $15, i can send you the jantzen inductor i am using.
https://www.parts-express.com/Jantz...5k235TNc1onuHXSEu7MUDBAV4FhBuYGxoCOdgQAvD_BwE
Sitting 10' away, i'd say the sweet spot is about 1' vertically, horizontaly as wide as any other 3 inch driver.
I had builder fill in where front baffle wasn't flush to box.
Was a squeek more low mids that wasn't there before.
Shark not included.
Money order please.
Thanks for looking !!!!!!!
4 x tg9 (copper cap) wired in series/parallel.
3/4" bb ply sides, top/bottom, back
1/4" front
1 : 1.618 ratios
6" deep x 9" wide x 15" tall
Acousta stuff inside
Rolls fast at 200hz.
If used for music, you will need a woofer, not a subwoofer.
Amazing intelligibility for late night listening to movies.
Think picking up on pink floyd division bell lyrics without focusing on them, it's that good.
I recommend baffle step circuit of 1.7mH + 2.5 ohms
For an extra $15, i can send you the jantzen inductor i am using.
https://www.parts-express.com/Jantz...5k235TNc1onuHXSEu7MUDBAV4FhBuYGxoCOdgQAvD_BwE
Sitting 10' away, i'd say the sweet spot is about 1' vertically, horizontaly as wide as any other 3 inch driver.
I had builder fill in where front baffle wasn't flush to box.
Was a squeek more low mids that wasn't there before.
Shark not included.
Money order please.
Thanks for looking !!!!!!!
Attachments
Last edited: