Hey all,
I have a Crown CTs2000 and a Crown CTs1200 both of which are dead with a similar fault, though the 2000 has a few extra parts that were suspect. The varistor in the power supply right after the bridge rectifier is blown on both. This is a part that on schematics of the two units, there are notes that that part should be removed. (these units are from about the 2002 vintage)
Has anyone here had similar experiences and could anyone here give me guidance as to if I replace maybe the filter caps and main relay and leave the varistor out as per the update notes, would that safely get the amp working again?
-Nicholas
I have a Crown CTs2000 and a Crown CTs1200 both of which are dead with a similar fault, though the 2000 has a few extra parts that were suspect. The varistor in the power supply right after the bridge rectifier is blown on both. This is a part that on schematics of the two units, there are notes that that part should be removed. (these units are from about the 2002 vintage)
Has anyone here had similar experiences and could anyone here give me guidance as to if I replace maybe the filter caps and main relay and leave the varistor out as per the update notes, would that safely get the amp working again?
-Nicholas