C-L-C-parallel-R-C

[wicked1]

Is there anything special to pay attention to when making a power supply that splits into parallel legs? I'm planning on
C-L-C-[(RC)(RC)(RC)(RC)] (so, four resistors attaching to that 2nd cap) It's for a phono amp w/ two gain stages, so each final RC will be powering one channels gain stage.

I'm not sure how to model something like that in psud.

Thanks

 

[Gordy]

I'm not sure how to model something like that in psud.

I don't think you can.

I am not an expert on psud, but I would be inclined to model the C-L-C section loaded down with three quarters of the predicted overall current load, then add a single RC filter + load on the end.

I too would like to hear what the more experienced folk have to say on this...