Hi guyz,
I'm doing the layout of my Aleph 2 driver board. Once its done I'll post it for comments from u guyz. I would like to know what is the trace width that u guyz normally use for driver boards. What is the trace width of Pass's amps? What about the driver board that everyone is using from the group purchase designed by BrianGT? I'm doing mine with 1.5mm for most of the traces in the driver board. Is that enough? I'll be most likely be using a 1oz board. If 1.5mm is too thin, what about changing to 2oz board?
Thankz guyz
Louis
I'm doing the layout of my Aleph 2 driver board. Once its done I'll post it for comments from u guyz. I would like to know what is the trace width that u guyz normally use for driver boards. What is the trace width of Pass's amps? What about the driver board that everyone is using from the group purchase designed by BrianGT? I'm doing mine with 1.5mm for most of the traces in the driver board. Is that enough? I'll be most likely be using a 1oz board. If 1.5mm is too thin, what about changing to 2oz board?
Thankz guyz
Louis