If I look at the schematic of the Aleph 2 in the service manual, it looks to me that the negative side of C9 and C10 are connected. And both are at the output side of the amp.
If I look at the schematic kristijan-k have done on his Internet page, http://web.vip.hr/pcb-design.vip/aleph-2.html, it is obvius to me that C9 and C10 are connected.
But if I look at BrianGT’s PCB layout, http://www.prism.gatech.edu/~gte619j/alephpcb/, I can’t see that the capacitors C9 and C10 are connected.
Please help me to figure out which one is right, or where I am wrong.
Best regards
/loovet
If I look at the schematic kristijan-k have done on his Internet page, http://web.vip.hr/pcb-design.vip/aleph-2.html, it is obvius to me that C9 and C10 are connected.
But if I look at BrianGT’s PCB layout, http://www.prism.gatech.edu/~gte619j/alephpcb/, I can’t see that the capacitors C9 and C10 are connected.
Please help me to figure out which one is right, or where I am wrong.
Best regards
/loovet
Hello,
The original Pass Aleph 2 have negative sides connected together,
like showh on my website.
However, If you connect them like Brian did, everything would be fine,
and circuit will perform pretty much the same.
Best regards,
Kristijan Kljucaric
http://web.vip.hr/pcb-design.vip
The original Pass Aleph 2 have negative sides connected together,
like showh on my website.
However, If you connect them like Brian did, everything would be fine,
and circuit will perform pretty much the same.
Best regards,
Kristijan Kljucaric
http://web.vip.hr/pcb-design.vip
Go here http://www.diyaudio.com/forums/showthread.php?threadid=2942&perpage=15&pagenumber=8 to read a little bit more on the discussion on the connection of C9 and C10. You might want to make a note on the value of C7 for BrianGT layout.
- Status
- Not open for further replies.