Advice for 10 channel amplifier

[yeshu26]

Good Evening

I am looking a wee bit of advice please.

It is my intention to build a 10 channel amplifier. Each stereo channel is about 170 mm in width and 90 mm in height.

The following chassis comes to my mind.
Dissipante 5U – diyAudio Store

Is it possible to squeeze three of these PCBs on each side based on the
40 mm heatsink 200 mm * 210 mm?

Please advice.

Thank you

Yeshu26

 

[rayma]

Will the transistors be at suitable locations on the heat sink, not too close together, or too close to the edges?

 

[yeshu26]

Good Morning

I intend to use Rod Elliot's P3A amp for this project.