• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

807 Amp

Status
Not open for further replies.
I haven't built it amp myself, but this offering by JC Morrison looks interesting (though there are a few ambiguities in the schematic). More info here.

How much power do you need? Triode-mode Class A PP 807 can achieve impressive distortion figures before feedback (0.6%), but power will be limited to around 6W.

807 UL anode characterstics from Audiomatica's website, just for interest.
An externally hosted image should be here but it was not working when we last tested it.


EDIT: How could I forget.... The "Ultra-Linear" amplifier by Hafler and Keroes here. It uses 6L6s, but they're basically 807s without topcaps.
 
Hi Jason,

I just need 10W amp for this tube. Thanks.

audiousername said:
I haven't built it amp myself, but this offering by JC Morrison looks interesting (though there are a few ambiguities in the schematic). More info here.

How much power do you need? Triode-mode Class A PP 807 can achieve impressive distortion figures before feedback (0.6%), but power will be limited to around 6W.

807 UL anode characterstics from Audiomatica's website, just for interest.
An externally hosted image should be here but it was not working when we last tested it.


EDIT: How could I forget.... The "Ultra-Linear" amplifier by Hafler and Keroes here. It uses 6L6s, but they're basically 807s without topcaps.
 
Status
Not open for further replies.