So I am wiring, (trying to) wire 636, EVs and SLB green bullet
to my TOA 900 preamp.
the input mods are mostly at 200 ohms
so i am using the low impedance outs on the evs, pins 3 and 4
and using a low impedance green bullet
also pins 3 and 4
with shield to ground on both sides to pin 1
and on the other side 2-3 and 3-4
although i have tried this both ways and i still have low sound and an obvious connection to the shield of the mic as when you touch it it lessens hum
please help, i know the connection on the TOA are backwards and i have on wired for 2 hot and for 3 hot and either way all noise and barely any real sound is being transduced to the amp
to my TOA 900 preamp.
the input mods are mostly at 200 ohms
so i am using the low impedance outs on the evs, pins 3 and 4
and using a low impedance green bullet
also pins 3 and 4
with shield to ground on both sides to pin 1
and on the other side 2-3 and 3-4
although i have tried this both ways and i still have low sound and an obvious connection to the shield of the mic as when you touch it it lessens hum
please help, i know the connection on the TOA are backwards and i have on wired for 2 hot and for 3 hot and either way all noise and barely any real sound is being transduced to the amp
- Status
- Not open for further replies.