SOLD
One set of complete and tested Miro AD1862 DAC with York + Reclock board (USB-I2S interface)
In my opinion, this is the most direct and best combo for the gem, AD1862.
Sounds wonderful. It is a full, completed DAC kit, equipped with a pair of AD1862N DAC chips and a pair of Signetics NE5534 op amp is included on board the IV stage.
Play with your own op amp to choose your flavor after that, although i can say that the NE5534 is an enjoyable result.
You need the following PSU:
1. +5/-5V (VD),
2. +12/-12V (VA) directly to the DAC board
The York board's 'dirty side' is configured to be powered by the USB Bus ie. drawing +5V from your USB source. This can be changed to be powered from a PSU of your choice if you wish. Can be done very easily by opening a solder bridge on the York board as instructed by the user guide, and then soldering two wires from pads available on the DAC board out to the PSU. The XO and reclock circuit of the York is drawing +5V (digital supply) from the DAC board when you stacked and isolation from the USB 'dirty side' is achieved. Very neat and clean design. The York's reclocker board has been upgraded with AS318B Accusilicon XO.
With the exception of the op amps which are old and used, all others parts used are bought brand new, including the AD1862N chips, for the purpose of putting up the DAC.
All caps are high quality ones including Nichicon gold, Elna Tonerex, Panasonic FM etc.
I am asking Singdollars 430 (approximately USD$330) for this DAC , and i will cover the worldwide registered shipping with tracking available.
I am only ready to accept Paypal Family and Friends as payment.
I have shipped 60+ packages to US, UK , asia and Europe, not a single glitch so far.
More information of this DAC here :
https://www.diyaudio.com/community/threads/dac-ad1862-almost-tht-i2s-input-nos-r-2r.354078/
https://www.diyaudio.com/community/...s-input-nos-r-2r.354078/page-128#post-6836256
One set of complete and tested Miro AD1862 DAC with York + Reclock board (USB-I2S interface)
In my opinion, this is the most direct and best combo for the gem, AD1862.
Sounds wonderful. It is a full, completed DAC kit, equipped with a pair of AD1862N DAC chips and a pair of Signetics NE5534 op amp is included on board the IV stage.
Play with your own op amp to choose your flavor after that, although i can say that the NE5534 is an enjoyable result.
You need the following PSU:
1. +5/-5V (VD),
2. +12/-12V (VA) directly to the DAC board
The York board's 'dirty side' is configured to be powered by the USB Bus ie. drawing +5V from your USB source. This can be changed to be powered from a PSU of your choice if you wish. Can be done very easily by opening a solder bridge on the York board as instructed by the user guide, and then soldering two wires from pads available on the DAC board out to the PSU. The XO and reclock circuit of the York is drawing +5V (digital supply) from the DAC board when you stacked and isolation from the USB 'dirty side' is achieved. Very neat and clean design. The York's reclocker board has been upgraded with AS318B Accusilicon XO.
With the exception of the op amps which are old and used, all others parts used are bought brand new, including the AD1862N chips, for the purpose of putting up the DAC.
All caps are high quality ones including Nichicon gold, Elna Tonerex, Panasonic FM etc.
I am asking Singdollars 430 (approximately USD$330) for this DAC , and i will cover the worldwide registered shipping with tracking available.
I am only ready to accept Paypal Family and Friends as payment.
I have shipped 60+ packages to US, UK , asia and Europe, not a single glitch so far.
More information of this DAC here :
https://www.diyaudio.com/community/threads/dac-ad1862-almost-tht-i2s-input-nos-r-2r.354078/
https://www.diyaudio.com/community/...s-input-nos-r-2r.354078/page-128#post-6836256
Last edited:
