• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Support boards for new Wolverine AMP (PSU, SSR, Ground Lift, Bal Input)

Jump to Latest
H

HRDSTL

Member
Joined 2022
#1
Since I'm plugged into the latest GB on the Wolverine amp, I'll be putting in a production pcb from the list below...

PSU Board (2oz blue)
power_supply_2pin_diodes_big_pcb_top.jpg power_supply_2pin_diodes_big_schematic.png

Small heatsinks SK 75 37,5 STS - price on request
sk75 37,5.png

MBR40250G - When ordering 100 pcs, the price on the mouser is already acceptable 😉

SSR protect (2oz blue)
HRDSTL-SPK-PROTECT-STUFF-400WBIG-DC.png HRDSTL-SPK-PROTECT-SCH-400WBIG-DC.png

Dual Ground Lift (2oz blue)
GND LIFT LAY.png GND LIFT SCH.png
Bal/Unbal input
bal_unbal input.png
Support psu for bal/unbal input
...in proggress

If anyone would like, just write me a private message. The deadline will be 4.5.2025 and the boards will be ordered.
 
Last edited:
You must log in or register to reply here.
Top Bottom