What would be the best way to go on about this? In the illustration its 1 inch from the sides even though it says 2 in the document ( I think the illustrations are reused from the finalists which are a similar speaker)? I'm a bit lost on it since that would significantly reduce the cutout area. the dimensions of the brace are 24cm x 34cm. the effective dimensions are 24cm x 30cm since lengthwise 4cm is sitting directly under mid driver tunnel bracing. What do you think about going with an ellipse or circle cutouts with the same surface of the illustrated? Should I just do 2 inches on the sides and leave the middle without any additional bracing? Or just do the window thing?
It just splits all the panels in half. Because of the rear holes its really the only option.
1 inch or 2 inch wont change much.
Vertical could be added which would strengthen the 1 inch cuts.
Either way the process is typically over thought.
Usually non symmetrical be more effective. The windows are cut to a 1/2 ratio. And the brace is mounted to 1/2 ratio.
So dont matter much.
Easier to use a hole saw. long as the minimum area is about a inch.
Its a circle, so some parts will obviously be thicker.
could be 1/3 ratio or 1/6 yada yada. why make it confusing
4 holes or 6. 6 makes the spacing to offset vertical.
Or just make them right in the center. Either way resonance goes up.
Not much energy of low resonant frequency in such a small box
Dont matter much its just one center brace.
Cabinet is already small wont take much to get it over 400 hz resonance.
might already be without the brace.
probaly close, but one brace assures it.
Im sure people will over analyze it to oblivion.
The speaker response is the same, and the baffle response is same.
So whoopi doo doo
1 inch or 2 inch wont change much.
Vertical could be added which would strengthen the 1 inch cuts.
Either way the process is typically over thought.
Usually non symmetrical be more effective. The windows are cut to a 1/2 ratio. And the brace is mounted to 1/2 ratio.
So dont matter much.
Easier to use a hole saw. long as the minimum area is about a inch.
Its a circle, so some parts will obviously be thicker.
could be 1/3 ratio or 1/6 yada yada. why make it confusing
4 holes or 6. 6 makes the spacing to offset vertical.
Or just make them right in the center. Either way resonance goes up.
Not much energy of low resonant frequency in such a small box
Dont matter much its just one center brace.
Cabinet is already small wont take much to get it over 400 hz resonance.
might already be without the brace.
probaly close, but one brace assures it.
Im sure people will over analyze it to oblivion.
The speaker response is the same, and the baffle response is same.
So whoopi doo doo
