Hello all
Im currently working to make a Smart Speaker that has a fully open source software stack, and a 3D printable enclosure (Eventually to be injection molded or milled) and would like to ask for some assistance desining an enclosure for a TEBM46C20N-4B
Ideally we are looking for the enclosure to be a 92mm cilinder, with the speaker down firing. The intended application would be for streaming music, and placed on a side tabel in a living room. Enclosure design is entirely new to me, and I dont know where to even begin.
Any advise as to how to design such an enclosure is greatly appreciated.
Im currently working to make a Smart Speaker that has a fully open source software stack, and a 3D printable enclosure (Eventually to be injection molded or milled) and would like to ask for some assistance desining an enclosure for a TEBM46C20N-4B
Ideally we are looking for the enclosure to be a 92mm cilinder, with the speaker down firing. The intended application would be for streaming music, and placed on a side tabel in a living room. Enclosure design is entirely new to me, and I dont know where to even begin.
Any advise as to how to design such an enclosure is greatly appreciated.
Something like this, just flipped around? These are Zenith Circle of Sound speakers I had noticed on an online auction and had to think of them when you mentioned round speakers.
-Justin
-Justin
Yes, we are looking for it to be equivalent or better sound quality to an Echo Dot v3. Our limitations or our knowledge on the subject of speaker enclosure design, calculating the cavity size and other features to improve the sound profile such as a horn or radiator. Reght now we dont know what knowledge we are missing.
yes something linke that would be amazing
Yes, it will be a commercial product, currently its going through a stage of being an Development board, with the intent to go to injection molding for an enclosure in the next 6 months.
We would be happy to pay for a designer, do you have any recomendations of anyone you know, or a good place to ask for skilled designers?
You can see the project over here
https://tectonicweb.wpenginepowered...gn-for-TEBM35C10-4-BMR-Driver_WSG_12OCT18.pdf
Tectonic provides an application note for a smaller driver, the TEBM35C10. It works in tandem with a passive radiator for compactness and low-end reinforcement. It should serve as a baseline.
Tectonic provides an application note for a smaller driver, the TEBM35C10. It works in tandem with a passive radiator for compactness and low-end reinforcement. It should serve as a baseline.
- Status
- Not open for further replies.