I have a plate amp to a REL Studio II (300 watts). I want to replace the power caps, but am having difficulty sourcing them. It seems replacements have a screw terminal or snap fitting. The OEM is a spade connector (solder):
10,000 UF
100 V
22.5 mm spade distance
45 mm diameter case
Height - doesn't matter (plenty of room in the enclosure)
Would someone suggest a replacement and how I can mount it to the board if spade is not possible any longer
Thanks
10,000 UF
100 V
22.5 mm spade distance
45 mm diameter case
Height - doesn't matter (plenty of room in the enclosure)
Would someone suggest a replacement and how I can mount it to the board if spade is not possible any longer
Thanks