rookie attempt atchecking this sectiion of HR out..... so far i have a strange looking overdamped super low tuned ....yuck. (I’m sure I’ve screwed up something (s))
it’s the 7” dayton epique driver and ‘one’ of the matching radiators at this point .
I need to add another. shoukd I add another Sd and Mmd in the PR section to perk up the low end extension section?
Last edited:
dang, sucker gets low(two 7" radiators) even without added mass? *i think * im
doing this correctly?
Last edited:
Looks close to a sim in a 26Hz Fb smaller box (yours is ~3 times Vas) using a SLAPs M8 (at 40.4mm excursion) about the same displacement as the 2 Dayton PR.
The driver specs seem a little different, your Mmd and BL are lower, Cms higher.
Not the cheapest way to make low end, but pretty tiny.
The driver specs seem a little different, your Mmd and BL are lower, Cms higher.
Not the cheapest way to make low end, but pretty tiny.
Last edited:
Ooops, I had the wrong Vas entered , thanks.
how crazy does the passive radiator get with such a radical xmech/max? Funky distortion or can we drive the heck out of it?
how crazy does the passive radiator get with such a radical xmech/max? Funky distortion or can we drive the heck out of it?
Last edited:
Good PRs work OK within the suspension limits, but the limit is pretty hard and abrupt.
I don't have any first hand experience with these passive radiators, so can't say specifically.
I don't have any first hand experience with these passive radiators, so can't say specifically.