Hey guys,
sorry if this already has been discussed. Got M-Dac+ which wouldn't start, found that the problem whic was in the thermal fuse which is sticked to primary windings.
Does any one has any info on secondary windings voltage and current requirements? While drilling of the epoxy filling of inside kern, managed to damage some of secondary windings. Only clue I have is the resistance od sec. windings:
Orange - Orange 0.9 ohm
Violet - yellow - Violet 2.2.ohm
Red -Red 0.2 ohm
Originally transformer is Noratel TI-149(?)
any comments would be appreciated
sorry if this already has been discussed. Got M-Dac+ which wouldn't start, found that the problem whic was in the thermal fuse which is sticked to primary windings.
Does any one has any info on secondary windings voltage and current requirements? While drilling of the epoxy filling of inside kern, managed to damage some of secondary windings. Only clue I have is the resistance od sec. windings:
Orange - Orange 0.9 ohm
Violet - yellow - Violet 2.2.ohm
Red -Red 0.2 ohm
Originally transformer is Noratel TI-149(?)
any comments would be appreciated