Hello everybody. I am struggling with a three way design. I want to have two mids and woofers in each box either in parallel or series. I have searched for an answer on how to treat the T/S parameters. The only thing I found (which I can't find again) was that Xsim will do this automatically. Could someone please point me in the right direction. BTW I realize it is a bit of a challenge but then I need a challenge!
Thanks
Peter
Thanks
Peter
XSim is a crossover modeler only and doesn't deal with Thiele/Small parameters. It works with impedance and frequency response files for the individual drivers. If that's what you are after, yes, it will handle as many drivers as you want configured however you lay them out.
The newer 3D version will also let you lay out the drivers on a baffle and do off-axis simulations.
The newer 3D version will also let you lay out the drivers on a baffle and do off-axis simulations.
Last edited:
Thanks for your replies. I have been playing around with the crossovers but I probably should have started with the box and baffles.
