My nobsound ns-20g amplifier dosent show any signs of overheating or lot of disturbance only little bit on high volume I have connected two bookshelf speaker 35w+45w both are 6ohms connected in parallel configaration which goes to 3 ohms
Per channel
My amplifier specs
Nobsound ns-20g
the output power is improved to 200W (100W*2) with 2PCS TPA3116 chip
Suits 5-8 inches / 4-8Ω / 20-120W speakers
Per channel
My amplifier specs
Nobsound ns-20g
the output power is improved to 200W (100W*2) with 2PCS TPA3116 chip
Suits 5-8 inches / 4-8Ω / 20-120W speakers
But I don't know if chip is parallel bridge or not can you find out for me
Amplifier Nobsound ns-20g
Amplifier Nobsound ns-20g
Yes 2 tpa 3116 chip in pbtl mode can drive 2 ohms.
100W per chip with 24 volt power supply, you need a good power supply, at least 200W minimum. This will depend on your listening volume and the possible heat dissipation of this small box...
100W per chip with 24 volt power supply, you need a good power supply, at least 200W minimum. This will depend on your listening volume and the possible heat dissipation of this small box...