I have a crossover schematic and also have the parts on hand. Its a 2 way design. Crossover will be mounted on a wood board and soldered underneath for looks. I want to put both the HF and LF crossover on same board if possible.
I need some help in the layout. I know to keep the inductors at angles if they are close.
Looking for something that visually looks good also.
I can post the schematic if needed.
Thanks!!
I need some help in the layout. I know to keep the inductors at angles if they are close.
Looking for something that visually looks good also.
I can post the schematic if needed.
Thanks!!
I would tend to layout something like that same as schematic so its easier to debug if theres a problem later on.
So this is a general layout. Input to crossover is on left. All wiring will be underneath board. Tried to keep all inductors apart or at angles to each other.
Move the four vertical resistors in the middle further downward,
and then move the largest inductor to the left, farther from the rightmost inductor.
and then move the largest inductor to the left, farther from the rightmost inductor.
Ok, and move the smallest inductor a little farther to the right.
Also space the power resistors as far apart as possible, for ventilation.
Also space the power resistors as far apart as possible, for ventilation.
