Hello, I have a skar SKV2 1500 and over the weekend my ground came loose on the amp and I’m assuming the amp went into protect mode. After reconnecting the ground, I am no longer getting any output. Any advice on what board components may have been impacted?
Post a good quality photo of the component side of the entire main board and the component side of any driver boards if no one can help.
Do you have positive and negative rail voltage?
Do you have positive and negative regulated voltage on the power supply pins of the op-amps?
Do you have positive and negative rail voltage?
Do you have positive and negative regulated voltage on the power supply pins of the op-amps?