Hello all, I have always been a fan of the hybrid amps, Llano Trinity, Moscode 600 are the two I'm most familiar with. I'm not an electrical engineer or audio guru, just a kit builder that can follow directions.
My question is, are there any of these power amp boards that could be easily used with a tube driver stage? I was looking at the "Honey Badger" kit, has anybody here done this before? I have a couple different driver stages I would like to "marry" to a high output amp. I have a couple of the boards for the upgraded Dynaco ST-70, one using 12AU7, the other using 6SN7, and then the Llano type is simple to build.
Any thoughts or advice would be appreciated,
Thanks,
My question is, are there any of these power amp boards that could be easily used with a tube driver stage? I was looking at the "Honey Badger" kit, has anybody here done this before? I have a couple different driver stages I would like to "marry" to a high output amp. I have a couple of the boards for the upgraded Dynaco ST-70, one using 12AU7, the other using 6SN7, and then the Llano type is simple to build.
Any thoughts or advice would be appreciated,
Thanks,
There is one, found here https://www.diyaudio.com/community/...nce-yet-rather-simple-hybrid-and-more.262450/. The designer passed away so I don't know about availability for pcb's.
I don't like the pwr amp. But you have done a very similar thing as I. I have a 0.006 thd mosfet amp driven by the tone stack which is driven by a 6922 tube. My set requires 40v p-p from tube to get 80 w of output