Hi! This is my first sub project. I am looking into a bass module to put my soon to be mini-karlsonator on top of.
I want to run this idea by some more knowledgeable folks, and this is the place to do that i expect!
I made this little drawing and I humbly ask for any advice that can be spared in pointing out how I might go about calculating or figuring out if this design will work.
I plan to build the cabinet out of 19mm thick plywood.
Well met! Marcus.
I want to run this idea by some more knowledgeable folks, and this is the place to do that i expect!
I made this little drawing and I humbly ask for any advice that can be spared in pointing out how I might go about calculating or figuring out if this design will work.
I plan to build the cabinet out of 19mm thick plywood.
Well met! Marcus.
I do not understand this at all. Why is there a baffled chamber above the driver?
For a Ripole you want two exits, and they should be on opposite sides of the enclosure. It's not like a vented box or TL...
Anyway Ripole is IMHO a dumb design. Why are you interested in it?
For a Ripole you want two exits, and they should be on opposite sides of the enclosure. It's not like a vented box or TL...
Anyway Ripole is IMHO a dumb design. Why are you interested in it?
Haha! I am not surprised, after all I am a beginner.
Purely out of estetic purposes! How would you go about changing this but preserve the characteristics of the design?
I am glad to hear this is not good enough so now lets revise it.
And if i may ask what makes it a dumb design? 🙂
Purely out of estetic purposes! How would you go about changing this but preserve the characteristics of the design?
I am glad to hear this is not good enough so now lets revise it.
And if i may ask what makes it a dumb design? 🙂
Hmm, assuming the motor/cutout is sealed it's a parallel 6th order band-pass (BP6p), if not, a leaky one. 🙁