Anyone know Sigma Studio simple programming and can help a brother out?
The programming is nearly done except one thing low pass volume, I must be missing something.
Any help would be unbelievably appreciated 🙂
The programming is nearly done except one thing low pass volume, I must be missing something.
Any help would be unbelievably appreciated 🙂
Do you just need a volume control for the channel? I use a single volume control sometimes for an easy solution.
Thank you so much for your reply. Kind of volume control but more like as one channel goes up another goes a little down. this is what I'm thinking:
It's a 4ch amp: channel 1 and 2 are stereo high frequency, 3 and 4 are bridged mono for low frequency.
At the moment it works great but when playing music at low volume the low frequencies are to soft OR when I turn up the master the low frequency channel 3 and 4 are to loud.
What I need is when I turn down the volume on all channels (master volume) I need channel 3 and 4 to get louder to a set point. and the opposite like when I turn up the master volume I need channel 3 and 4 to get softer to a point.
I'm sure it's doable but just need a head start.
Thanks heaps 🙂
It's a 4ch amp: channel 1 and 2 are stereo high frequency, 3 and 4 are bridged mono for low frequency.
At the moment it works great but when playing music at low volume the low frequencies are to soft OR when I turn up the master the low frequency channel 3 and 4 are to loud.
What I need is when I turn down the volume on all channels (master volume) I need channel 3 and 4 to get louder to a set point. and the opposite like when I turn up the master volume I need channel 3 and 4 to get softer to a point.
I'm sure it's doable but just need a head start.
Thanks heaps 🙂
There’s loudness features that should do just that. I’m not familiar with them but I know they exist somewhere in the toolbar.