I want to use these 4 independent subs in a swarm like distributed bass array with dirac bass control dsp. I am told the dirac dsp will only work with mono subs so I am wondering how to connect the 4 subs to the VTV nc1200 stereo amp. This amp has one channel inverted to avoid power supply pumping. Can I bridge the nc1200 and simply run a wire from the + on one channel to each sub and a wire from the - of the other channel to each individual sub? The subs are 4ohm each and the nc1200 can handle 2ohm loads unbridged so 4ohms should be ok- if I put 2 sets in series, then those two sets in parallel, I should have a 4 ohm total load. Is this the way to go? Thanks.
