I am taking apart a NAD T750 and it has a vertical volume circuit board that connects directly to the (horizontal) main circuit board. There are two board-to-board connectors to detach and one of these easily pulls up without any manipulation but the other one does not budge. On another forum it was suggested that I tried pulling on what looks like latches on the sides while I pull the board up, but that part of the connector does not seem to move at all. If anyone has come across this type of connector I would appreciate any advice!
:
:
It will release 🙂
The centre cutout looks like a clip. Just slip a thin blade in from above to slightly force the two apart and wiggle it out.
The centre cutout looks like a clip. Just slip a thin blade in from above to slightly force the two apart and wiggle it out.
I was thinking more from the top tbh to separate the two pieces but these connectors will always come apart with a bit of persuasion.