Probably not many UPVs owned privately, however future will tell.
As with the rest of the Audio Analyzers from R&S, the UPV is discontinued as the AKM ADC is no longer available.
There are a few variations as already known from previous UPL/UPD units.
<February 2007 with FMR6 RS232, LPT and VGA output
Not sure at the moment if by using a FMR9 with a pre 2012 Digital Board will let you run the RS232 ports for example.
Versions after 2015 can be equipped with and SSD as the main drive, whereas the olders ones use a Fujitsu 5400rpm 40GB.
Pictured, FMR6 1.5GHz Celeron unit with 512MB of RAM DDR2.
As with the rest of the Audio Analyzers from R&S, the UPV is discontinued as the AKM ADC is no longer available.
There are a few variations as already known from previous UPL/UPD units.
<February 2007 with FMR6 RS232, LPT and VGA output
Not sure at the moment if by using a FMR9 with a pre 2012 Digital Board will let you run the RS232 ports for example.
Versions after 2015 can be equipped with and SSD as the main drive, whereas the olders ones use a Fujitsu 5400rpm 40GB.
Pictured, FMR6 1.5GHz Celeron unit with 512MB of RAM DDR2.
Attachments
Powered my UPV last night for likely the first time in 6-7 years. This process generated a "CMOS checksum error - Defaults loaded"
screen message. I had the UPV repaired and cal'd at R&S in Columbia, MD in 2014.
screen message. I had the UPV repaired and cal'd at R&S in Columbia, MD in 2014.
Likely culprit is battery. I'll break the Cal seal, document with photos, and replace battery.
Hopefully, resolution will ensue!
Hopefully, resolution will ensue!