I'm selling a pair of nearly-new ApexJr MegaBass 250W class AB Subwoofer Plate Amplifiers. Specs below. I was planning stereo subs in traditional boxes, but I ended up going with sonotubes, making a fully enclosed amp a better fit for my purposes. I tossed the boxes and cut the female spade connectors off the speaker leads, but they are otherwise as I purchased them a few months ago. Stock IEC cables included if you want them.
They are $150 +shipping each new. I'd take $110 each or $200 for the pair +shipping, domestic (US) or internationally.
Paul
They are $150 +shipping each new. I'd take $110 each or $200 for the pair +shipping, domestic (US) or internationally.
Paul
| 250Watt RMS at 4 Ohm Class A/B | |
| On-Auto-Off - 115V/230V Switchable - Signal to noise ratio <90dB | |
TOTAL HARMONIC distortion <1% - Variable phase control 0-180 | |
| Low pass filter control 0-180Hz and Bypass - Bass level control | |
Speaker and line level inputs. Freq response 20Hz-160Hz | |
| High level input and output sensitivity 2.5V | |
| Low level input and output sensitivity 180mV |
Attachments
About 10.5" x 10.5". They are actually just a bit smaller and close to, but not quite, square. 3.5" or so deep (the PT, everything else is shallower).
Paul
Paul
I am open to offers. I'll also consider trading for (with cash either way as necessary:
- a decent streamer (could include cash on my end).
- just the right 'scope or signal generator that is both nifty and more reliable than mine, but where shipping isn't too ridiculous
- good high voltage film caps for the next version of the power supplies in my 845 amps
- slightly taller stands for big vintage monitor type speakers than what I've currently got
- Tubelab TSE boards? (old Powerdrive boards would be the dream)
I'm thinking that postage to Australia would cost about $100-USD
Which makes these a bit on the expensive side of affordable
Which makes these a bit on the expensive side of affordable
