Amp power up but there output I resolder the inductors that are in the center circled the legs are broken off of them and the glue was not holding to the board anymore and also the three capacitors in the center two or fully detached from the board when it arrived they were none bipolar capacitors and I replace them with bipolar capacitors would that affect the cell from being able to travel to the outlets or where should I check next
Attachments
The caps in the photo are polarized capacitors and not suitable if they connect between ground and the output of the amplifier.
That makes a lot of sense. Do you know where I can find the right caps that go in that amplifier because when I ordered those from Mouser they didn't have the nun polarized caps in stock
I use the Panasonic E2106JF. The E2106KF will work as well.
https://octopart.com/search?q=E2106+panasonic¤cy=USD&specs=0
https://octopart.com/search?q=E2106+panasonic¤cy=USD&specs=0
