Glassware Aikido 8A and 9A 2006 rev. A

[gary s]

Hi everyone, does any member here on the Forum have the documentation for the Glassware Aikido 8A and 9A linestage boards. These are marked as 2006 Rev. A. I bought these many years ago from Tubecad and have lost the documentation after a move. I have emailed Tubecad but no response. Picture of the 2 pcb's is attached, thanks.

 

[kmtang]

https://www.yumpu.com/en/document/read/28723739/aikido-all-in-onepdf-tube-cad-journal

 

[gary s]

Thanks for the link, but it is not the same PCB.

 

[jameshillj]

I should have those somewhere here, Gary - I'll have a look tomorrow - it's both the 8 and 9 pin versions, right? I'm in Melbourne if that's any help.

 

[gary s]

Yeh, I have both boards here - 8 and 9 pin. Looking for the assembly manual, schematics etc that were supplied with the boards, which I have lost. I am in country NSW, thanks. Would like to get them into service if at all possible.

 

[woodturner-fran]

I might have these somwhere, but would need to find them! If you don't get sorted, come back to us.

 

[gary s]

OK, thanks for the reply, I will see if James can find them first.

 

[SCD]

here you go for the octal

 

[gary s]

Thanks so much for the octal documentation - now for the 9 pin version.

 

[stonegreen]

Here for nine

 

[woodturner-fran]

I went looking - I have a paper copy of the octal, but the only nine pin version was a headphone amp he did a small number of with mosfet outputs.

 

[gary s]

Thanks guys, a big thank you to members SCD and stonegreen for supplying the manuals. Now I have some work to do - along with many other amps.

 

[jameshillj]

Thanks guys - saved me poking thru the old boxes - if you need any bits Gary, just shout as I've got a few different tubes, etc like the 6SN7 lot - I remember getting extremely good results with the Salas high voltage reg as the power supply and might still have a kit/pcb around.

 

[gary s]

Thanks James, I will send you a PM.