My Jeff Rowland Model One is stuck in stand-by mode. Pushing the front button nothing happens (*).
Any suggestions to fix this issue?
I would also appreciate any suggestions for disassembling the unit, as this does not seems so easy.
Thank you very much.
(*) In a working unit, pushing the front button causes the passage to operating mode, and you can hear the click of a relay and see the indicator bulb increase in brightness
Any suggestions to fix this issue?
I would also appreciate any suggestions for disassembling the unit, as this does not seems so easy.
Thank you very much.
(*) In a working unit, pushing the front button causes the passage to operating mode, and you can hear the click of a relay and see the indicator bulb increase in brightness
Thank you for answering, Jan.
No click, and the bulb remains dim. The four small yellow leds on the board attached to rear panel light up.
No click, and the bulb remains dim. The four small yellow leds on the board attached to rear panel light up.
If you mean the fuses on the side boards (two fuses on each board), then yes, I did that check.
Are there any other fuses (besides the one on the mains socket) ?
Paul
Are there any other fuses (besides the one on the mains socket) ?
Paul
No it was just a question, sometimes these obvious things are overlooked.
Like making sure that there is actually mains getting into the unit ;-)
Jan
Like making sure that there is actually mains getting into the unit ;-)
Jan