I bought the Parasound 5125 cheap to use as a donor case from a seller who bought it local and basically got ripped off. He told me the amp wouldn't fire up and clicked when turned on but had no lights on the front and nothing seemed to work. I really only wanted it for the case, but did some troubleshooting for fun and figured out that 4 of the 5 amp boards had problems while the 5th seemed to be perfectly fine. The amp was actually going into protect immediately upon powering up but the original seller had opened it up and unplugged all the leads going to the front LEDs and one of the amp boards with a melted FET. After removing the 4 bad channels, I tested the single board to moderate volume levels and it works fine. As I'm tearing down the PS amp for the case and the main/input boards for a Icepower project I thought someone could use the single PS channel board.
I pulled it out of a 5125 where it was one of 5 identical boards, but according to the writing on the board it also fits a 2250 as the left channel.
$40 shipped to the lower 48.
I pulled it out of a 5125 where it was one of 5 identical boards, but according to the writing on the board it also fits a 2250 as the left channel.
$40 shipped to the lower 48.
Last edited: