There is demand for Aluminum knob .
many countries dont have it online or offline
So i have created a metalknob with diy method .
-no laathe or solid Aluminum needed
-just metal scissor and dremel
some super glue,putty ,silver powder
process is easy to understand from pics
An alu- L shaped braket was cut for outer and top sheet of Aluminum
paper based lower former is made with glue.
make the metal surface rough.
glue top plate
then glue peripheri with caution
lastly you make 2holes for end fixof periphery plate.
use resin or strong super glue .
All will be done with small gap at the edge.
fillthe cap with putty+silvepowder or paint.
let it dry.
final look will be solid metal
--
now we need tomake it heavy
we can use cement fill half and use a epoxyputty to make shaft hole.
i will give more detail on how to do shaft hole in next posts.
(it is for people in need ...whoever can buy online they can skip this)