Hi folks, I am at the point where I am wiring the input/outputs of the WHAMMY. I have the WHAMMY chassis that comes with the full kit. I removed the anodized finish where the six chassis plates meet, around the chassis ground screw, and where the volume pot meets the chassis.
Question: Do I need to ground the pcb to the chassis? If so, can I do it by removing the anodized finish where the stand-offs that hold the pcb pass through the chassis?
Many thanks,
John
Question: Do I need to ground the pcb to the chassis? If so, can I do it by removing the anodized finish where the stand-offs that hold the pcb pass through the chassis?
Many thanks,
John
You're welcome!
Also if you're experiencing noise related to grounding, try grounding the volume pot with a wire to the PCB ground. This would happen if the chassis doesn't have enough conductivity to connect the volume pot body to chassis ground.
Also if you're experiencing noise related to grounding, try grounding the volume pot with a wire to the PCB ground. This would happen if the chassis doesn't have enough conductivity to connect the volume pot body to chassis ground.