Good day guys im working on an amp (red board) but I need an expertise in making a suitable replacement for that cap value 224k100 (the actual one is 224J100), I took those larger ones from a tv board ac in section, it’s known to parallel caps for higher capacitance and series for less. Can those be used in series to represent the value I need or they’re not suitable for use on the output of a mono amp in parallel to the + & - out?
In conjunction also with a 1k 2watts resistor across the output.
In conjunction also with a 1k 2watts resistor across the output.
It’s a Precision Power amp (think it falls under Soundstream)...the three main output filter caps was blown also, I’ve replaced them but I haven’t tested the amp yet based on my previous question about capacitor substitution. Ive just put the busted ones on the amp to take a full picture
You can probably use the ones you pulled but why not order the right part?
Most class D amps aren't sensitive to the caps at this point in the circuit but some that pull feedback from this point in the circuit could be.
Most class D amps aren't sensitive to the caps at this point in the circuit but some that pull feedback from this point in the circuit could be.