Hi,
I am assembling my tone control module with bypass but have some doubts. Please see attached picture. I am using Latching push switch having six terminals. The stereo input signal from source will be on center pins when pushed the input signals will go directly to output. When in other posisiton the input will go to bottom pins > to tonearm module to > Output which will be connected to same pins as shown.
my questions is
When in position 2 Input goes straight to the output BUT it also has tone control output wires conneced (however input connection on tone control board will be OPEN )
Will that work ?
Because in reality when in bypass mode I will not only be supplying direct signal to output but also to out put of tonecontrol board. As shown in pic no. 2
Tonecontrol board will have power on contineously.
Thanks
I am assembling my tone control module with bypass but have some doubts. Please see attached picture. I am using Latching push switch having six terminals. The stereo input signal from source will be on center pins when pushed the input signals will go directly to output. When in other posisiton the input will go to bottom pins > to tonearm module to > Output which will be connected to same pins as shown.
my questions is
When in position 2 Input goes straight to the output BUT it also has tone control output wires conneced (however input connection on tone control board will be OPEN )
Will that work ?
Because in reality when in bypass mode I will not only be supplying direct signal to output but also to out put of tonecontrol board. As shown in pic no. 2
Tonecontrol board will have power on contineously.
Thanks
Last edited:
Take the centre pin of the switch and make that the Output.
Thanks. I got that.
1) as The tone control board will always be on with 12-0-12v supply. Will that inject any noise or as such ?
2) I guess since input wires will still be connected to tone control board as well as output to power amp. (Both being high impedance will be parallel) but still will not have any detrimental effect ?
regds
1) as The tone control board will always be on with 12-0-12v supply. Will that inject any noise or as such ?
2) I guess since input wires will still be connected to tone control board as well as output to power amp. (Both being high impedance will be parallel) but still will not have any detrimental effect ?
regds
1/ The input to the tone board should not inject into any noise into the stage driving it which would be assumed to have a low impedance.
2/ Should be no detrimental effect because you should be driving the tone board or power amp from a low impedance.
2/ Should be no detrimental effect because you should be driving the tone board or power amp from a low impedance.
See My Thread And Kindly Help Me.
https://www.diyaudio.com/community/...ers-together-at-same-time.383273/post-6947721
Sorry for delay in update as the progress was slow. I did follow your instruction but used 6 pin push switch. Details are HERE.
So far no clicking or such noise when tone switch is operated. I took advantage of having 6 pins so connected ground wire (both channels) so when tone board is bypassed the out put of both channel signal wires along with ground is lifted off.
Thanks and regards.