Howdy folks, i've just built some 2 way active stereo monitors using a Sure/Wondom JAB5.
I'm using 1 channel per driver, so 4 channels.
Am trying to figure out how to use the software, i've watched the Wondom instructional video as well as a few others online. Most appear to indicate that i should be able to listen to sound whilst having the ICP1 programming module - so i can tune on the fly.
however so far i can't get sound out of the amp when the ICP1 module is connected. (i do get sound when it's disconnected)
I've got the hardware configured as per Wondom's instructions, the USB is green indicating it's connected.
I've got the inputs set up and DAC's set up for the output in the schematic.
Any comments/suggestions on how i can get sound from the amp while i'm tuning the crossovers? Would prefer not to have to write, disconnect, listen, reconnect, adjust, disconnect, listen etc etc etc.
Thanks!
I'm using 1 channel per driver, so 4 channels.
Am trying to figure out how to use the software, i've watched the Wondom instructional video as well as a few others online. Most appear to indicate that i should be able to listen to sound whilst having the ICP1 programming module - so i can tune on the fly.
however so far i can't get sound out of the amp when the ICP1 module is connected. (i do get sound when it's disconnected)
I've got the hardware configured as per Wondom's instructions, the USB is green indicating it's connected.
I've got the inputs set up and DAC's set up for the output in the schematic.
Any comments/suggestions on how i can get sound from the amp while i'm tuning the crossovers? Would prefer not to have to write, disconnect, listen, reconnect, adjust, disconnect, listen etc etc etc.
Thanks!
Did you try the suggestion on page 44 of the manual, section 2.b. ?
https://www.parts-express.com/pedocs/manuals/dayton-audio-dspb-user-manual-v1_21.pdf
https://www.parts-express.com/pedocs/manuals/dayton-audio-dspb-user-manual-v1_21.pdf
Hi Mark, thanks yes I’ve tried disconnecting and reconnecting. I have no problem getting sound from the amp when the pc control module is disconnected. I didn’t realise the partsexpress amps were the same as the sure/wondom. Will have a look at partsexpress in case they offer any other suggestions.
Thanks for replying 🙂
Thanks for replying 🙂
Indicates i should be able to tune real time, but i cant' figure out how to get audio from the speakers while the amp is connected to the PC control module and my pc..