Yes another iNuke thread. Sorry.
I have two iNuke 3000 boards here. No signs of damage, one brand new, the other only a few hours on it.
Both have the same issue.
Upon powering up, they start. Both rails come up to +/- 76V and immediately start to drain down.
So the power supply is shutting off right away.
One worked fine yesterday, and upon first turn on this morning this happened. No arcs, no flashes no pops. Just powers up and powers down.
Neither amp was previously used, but have been sitting around for a few years.
Any ideas?
I have two iNuke 3000 boards here. No signs of damage, one brand new, the other only a few hours on it.
Both have the same issue.
Upon powering up, they start. Both rails come up to +/- 76V and immediately start to drain down.
So the power supply is shutting off right away.
One worked fine yesterday, and upon first turn on this morning this happened. No arcs, no flashes no pops. Just powers up and powers down.
Neither amp was previously used, but have been sitting around for a few years.
Any ideas?
Looks like the protection circuits are kicking in. Check the specified mains/wall voltage and then check that your amps are specified for that. In my case 245V AC was above the specified input voltage for te amp I was using (not a Nuke).
