Hi, iv been having trouble finding a cross fader for my BEHRINGER DDM4000
I at 1st tried the Infinium X1 but it did not work. it just got hot.
im buying a replacement however to make sure it was not down to a faulty fader. if this fader does not work however then my mixer is basically dead in the water unless i can get a fader back on.
My options are as follows.
Connect a 4 pin Behringer CFM-1 OR 5 pin Behringer CFM-2 fader
to the board of the DDM4000
Now being a new born novice i have no idea how to go about this, moreover i dont even know if it would work.
Has anybody sucsefully attempted to do this on either a DDM4000 or any other mixer.
If so i would be greatfull for any advice you may have to offer.
thank you.
pics of CFM-1 CFM-2
4pin — ImgBB
5pin — ImgBB
Pic of the original DDM4K fader
49-BC5-DC3-8916-414-D-9792-3712-CABA69-A5 — ImgBB
I at 1st tried the Infinium X1 but it did not work. it just got hot.
im buying a replacement however to make sure it was not down to a faulty fader. if this fader does not work however then my mixer is basically dead in the water unless i can get a fader back on.
My options are as follows.
Connect a 4 pin Behringer CFM-1 OR 5 pin Behringer CFM-2 fader
to the board of the DDM4000
Now being a new born novice i have no idea how to go about this, moreover i dont even know if it would work.
Has anybody sucsefully attempted to do this on either a DDM4000 or any other mixer.
If so i would be greatfull for any advice you may have to offer.
thank you.
pics of CFM-1 CFM-2
4pin — ImgBB
5pin — ImgBB
Pic of the original DDM4K fader
49-BC5-DC3-8916-414-D-9792-3712-CABA69-A5 — ImgBB
There are many Infinium faders with different pinout. Some are analog, some are serial.
There is another thread on this forum regarding the DDM4000. I believe it's just a matter of switching wires in the connector.
This one should work:
Behringer X1 – Thomann UK
Send them an email with pictures.
I have bought many gear from them, and they have good technical service.
There is another thread on this forum regarding the DDM4000. I believe it's just a matter of switching wires in the connector.
This one should work:
Behringer X1 – Thomann UK
Send them an email with pictures.
I have bought many gear from them, and they have good technical service.