I currently have 4367s and want to start playing with external crossovers, bi-amping, convolution filters, etc. That said, this is my main system and I'd like to maintain the passive crossovers and normal system signal path through my integrated amp as the baseline while I'm not messing around over the next however months (years?!?) doing this.
So I've been thinking about two options:
(1) a custom binding post plate with one set of binding posts for the passive xover and another 4 pole speakon connector that would be direct to the drivers (with protection cap on the compression driver). Then just a simple switch or set of switches to flip between.
(2) pull the xovers out of the speakers and put them in a separate enclosure by the rack and then have one set of cables to the speakers.
Am I crazy, anyone do something similar, recommendation on parts to use, high quality switches? Anything I do the goal would be to not mess with the stock parts such that it could be put back to stock at any time.
Thanks!
So I've been thinking about two options:
(1) a custom binding post plate with one set of binding posts for the passive xover and another 4 pole speakon connector that would be direct to the drivers (with protection cap on the compression driver). Then just a simple switch or set of switches to flip between.
(2) pull the xovers out of the speakers and put them in a separate enclosure by the rack and then have one set of cables to the speakers.
Am I crazy, anyone do something similar, recommendation on parts to use, high quality switches? Anything I do the goal would be to not mess with the stock parts such that it could be put back to stock at any time.
Thanks!