Hi does anyone have a schematic for an Orion Xtrpro 1000 please?
Looking for the output gate resistor value?
Looking for the output gate resistor value?
_IMG_20200925_170930.jpg)
I was referring to the IC in the center of the board. See attached.
The photos I have don't show the resistors you need very well. It's common to see 100 ohm resistors in the amps with parallel diodes. This one has no diodes. The photos look like the resistors may be 10 ohms. This is not definitive. If you're not rushed to get it repaired, give it some time to see if someone can give you a definitive answer.
If the outputs failed, It's unlikely that the 40N10 will work. The IRF3710Z is all that I found that worked universally in the 4080 amps.
The photos I have don't show the resistors you need very well. It's common to see 100 ohm resistors in the amps with parallel diodes. This one has no diodes. The photos look like the resistors may be 10 ohms. This is not definitive. If you're not rushed to get it repaired, give it some time to see if someone can give you a definitive answer.
If the outputs failed, It's unlikely that the 40N10 will work. The IRF3710Z is all that I found that worked universally in the 4080 amps.
Attachments
So do you think the 40N10 outputs are non originals ?
should they be IRF3710Z?
The amp came with 40N10 outputs installed, although they looked like they had all been replaced at some stage.
should they be IRF3710Z?
The amp came with 40N10 outputs installed, although they looked like they had all been replaced at some stage.
With the 4080 amps, there are amps that originally had the 40N10 or the non-Z version of the 3710 that the original part numbers will not work properly. In those amps, the IRF3710Z has always worked for me.