I built a Tubelab SSE amp a few years ago. It runs fine but I haven’t used it much over the last year. It remained on the board I built it on and has been sitting unused. I fired it up last night for a CD side to make sure all is good and then stripped it off the board this morning.
Edcor power transformer: (1) XPWR059 /120/ 240
Edcor output transformers (2) CXSE25-8-5K
The laminate on the outputs has very minor surface rust. I can rub most of it off with my thumb. Doesn’t hurt the transformer.
All three $250 shipped in the US. Paypal.
Populated Tubelab SSE PCB with Auricaps: $65 shipped in US.
Silicon diodes were installed initially but cut off the board at some point. I’ve never had an issue listening to this amp.
I will include the tubes with the board (2) JJ EL 34, (1) JJ ESS 81, (1) GZ 34 S, for $110.00 shipped in US. Paypal.
Edcor power transformer: (1) XPWR059 /120/ 240
Edcor output transformers (2) CXSE25-8-5K
The laminate on the outputs has very minor surface rust. I can rub most of it off with my thumb. Doesn’t hurt the transformer.
All three $250 shipped in the US. Paypal.
Populated Tubelab SSE PCB with Auricaps: $65 shipped in US.
Silicon diodes were installed initially but cut off the board at some point. I’ve never had an issue listening to this amp.
I will include the tubes with the board (2) JJ EL 34, (1) JJ ESS 81, (1) GZ 34 S, for $110.00 shipped in US. Paypal.
