• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Community M200 drivers, TOA horns, Peerless, etc.

One pair of NIB Community M200 midrange compression drivers. These are 2" throat drivers that go from 400-4kHz, very flat except for a very narrow notch around 3.2kHz. Low distortion. $375.

https://www.communitypro.com/sites/default/files/M200.PDF

I also have one matching SH494 horn. $75, but shipping on it will be expensive due to the size.

https://www.communitypro.com/sites/default/files/SH494_spec.pdf

One TOA HCD-904 horn/compression driver combo. 90 x 40. 630Hz minimum crossover. 16" x 6.5" x 10" (D). $50

Two TOA PCD-690 horns. One with piezo driver, one without. $10/pair.

One ProSystems 4660 1.375" compression driver. $25.

Pair Peerless 811655 1" soft dome, horn loaded tweeters. Around 95dB sensitivity. $45

Photos at link below.

Dropbox - Speaker - Simplify your life

Prices do not include shipping. Will ship international, but I will charge extra for this depending on the amount of unreasonable time it takes to do paperwork. Shipping drive units with charged magnets in them, can require a lot of time, especially if they will be sent by aircraft.

All drive units are located in the Northern California Bay Area.
 
Last edited: