Hi everyone, i have a AV50 prologic receiver which just powers on and the power led goes from amber to solid red, there's no flashing red. There is nothing on the LCD display. I've also tried to press different buttons to "wake it" but no response.
Is there someone who knows what this solid RED led means? I've emailed ARCAM and they actually said they don't have a specific fault for this. I'm requested a service manual from them.
Unforuntately i don't have the remote anymore, so can't do any troubleshooting with that.
Thanks in advance.
Is there someone who knows what this solid RED led means? I've emailed ARCAM and they actually said they don't have a specific fault for this. I'm requested a service manual from them.
Unforuntately i don't have the remote anymore, so can't do any troubleshooting with that.
Thanks in advance.
If Arcam --quote- "don't have a specific fault condition for this "-end quote then there is a major processing fault on your receiver.
It could mean a fault in the processor or a technical condition causing this kind of fault, if it was a flashing red light I would point to an offset voltage or output device failure but in some cases it turned out to be the chip itself was faulty.
It could mean a fault in the processor or a technical condition causing this kind of fault, if it was a flashing red light I would point to an offset voltage or output device failure but in some cases it turned out to be the chip itself was faulty.
