Hi ive got this amp the power block was melted so ive replaced it but the amp stays in protection no blown transistors and no blown mosfets on the power supply section any idea what it could be any help will be appreciated. If any close up pictures needed i will take them and upload them
Attachments
So. it just stays in protect, no matter if powered directly or through the limiter?
Does it try to produce any rail voltage or does the rail voltage remain at 0v.
Does it try to produce any rail voltage or does the rail voltage remain at 0v.
Yes stays in protection no matter what and it does try to build rail voltage goes about to +30v on positive rail and - -30v then goes into protection. I didnt check if there is dc on the output but will check that now also