Hi there,
Picked up a Sony XM-3060 with a missing RCA shield, hoping it would be an easy fix. Well turns out not so easy finding the 10 pin RCA jack that Sony used. I checked all the other RCA"s I had to see if I could remove a shield and pop it on with no luck. I can find 9 pin RCA's that look like they may work. As far as I can tell A-F are the positive inputs and the three G's are the negative shared ground. I don't believe the tenth pin between D and E does anything
here's a couple possible replacements?
thanks for your time
Amazon.com: uxcell AV Concentric Outlet 6 RCA Female Jack 9-Pin Connector Socket Panel Mount 5pcs: Electronics
Input RCA jack for HiFonics, Autotek, Crunch,Lanzar, ect | eBay
Picked up a Sony XM-3060 with a missing RCA shield, hoping it would be an easy fix. Well turns out not so easy finding the 10 pin RCA jack that Sony used. I checked all the other RCA"s I had to see if I could remove a shield and pop it on with no luck. I can find 9 pin RCA's that look like they may work. As far as I can tell A-F are the positive inputs and the three G's are the negative shared ground. I don't believe the tenth pin between D and E does anything
here's a couple possible replacements?
thanks for your time
Amazon.com: uxcell AV Concentric Outlet 6 RCA Female Jack 9-Pin Connector Socket Panel Mount 5pcs: Electronics
Input RCA jack for HiFonics, Autotek, Crunch,Lanzar, ect | eBay
Attachments
You can take shields and move them from one jack to another. They are held in by friction.
The diagram doesn't match your board, does it?
Does the extra contact show 0 ohm continuity to any of the other terminals?
The diagram doesn't match your board, does it?
Does the extra contact show 0 ohm continuity to any of the other terminals?
Last edited:
getting closer. Turns out Sony shared the part with the TA-E77ES(D)
Agoraquest • View topic - TA-E77ES - photos
Agoraquest • View topic - TA-E77ES - photos
This is what's inside.
Virtually any jack that has the exposed tab at the top and bottom will likely work.
Do you really want gold? The finish is damaged the first time that you plug in a cable. Chrome is better is virtually every way.
When you get the jacks repaired or replaced, bend the top and bottom tab so that it cannot easily pull out.
Virtually any jack that has the exposed tab at the top and bottom will likely work.
Do you really want gold? The finish is damaged the first time that you plug in a cable. Chrome is better is virtually every way.
When you get the jacks repaired or replaced, bend the top and bottom tab so that it cannot easily pull out.
Attachments
I was looking for gold to keep it original. These look like they will work if I remove the shields, found some even cheaper
Amazon.com: ZXHAO PCB Mounted AV Concentric Outlet 4 RCA Female AV4-7 10pcs: Home Audio & Theater
thanks for your help
Amazon.com: ZXHAO PCB Mounted AV Concentric Outlet 4 RCA Female AV4-7 10pcs: Home Audio & Theater
thanks for your help
Last edited:
- Home
- General Interest
- Car Audio
- Sony XM-3060 RCA