What type have soundcharacter close by the genuine used by the MS3.10 (MS310) ??
http://www.limundo.com/slika-Mordaunt-Short-MS-3-10--530361x640.jpg
http://www.limundo.com/slika-Mordaunt-Short-MS-3-10--530361x640.jpg
Last edited:
No informations?
According the pics I have found there are two different low-midrange drivers (transducers) in use:
1) smooth surface of polypropylene diaphragm
2) rough membrane surface
What are the sound differences und who was the manufacturer of the low-midrange driver?
According the pics I have found there are two different low-midrange drivers (transducers) in use:
1) smooth surface of polypropylene diaphragm
2) rough membrane surface
What are the sound differences und who was the manufacturer of the low-midrange driver?
Attachments
Last edited:
about
Customer Care System
is to read:
All MS product built before 1998 was built by a different company to us. We regret that as these designs are not our intellectual property we have almost no information on the older designs but a UK company called Lockwood audio can provide some spares and service for them. They are contactable on 0044 208 5797755.
MS designs of this vintage generally were 6 Ohms with a sensitivity in the high 80's and a power handling of about 100w RMS
Lockwood Audio
There I will ask
Customer Care System
is to read:
All MS product built before 1998 was built by a different company to us. We regret that as these designs are not our intellectual property we have almost no information on the older designs but a UK company called Lockwood audio can provide some spares and service for them. They are contactable on 0044 208 5797755.
MS designs of this vintage generally were 6 Ohms with a sensitivity in the high 80's and a power handling of about 100w RMS
Lockwood Audio
There I will ask
Until now I don't get a reply from there. Therefore now I am looking arround to a special company, which can carry out a restauration (not only foam surround replace like
Replace a Speaker Foam Surround - YouTube
but additional carry out the re-manufacturing (re-build) the voice coil and cone/diaphragm) like
Meyer Repair Service: Fender Speakers
but specialized to this transducer model from MS3.10.
Perhaps in Great Britain such a company exist.
Replace a Speaker Foam Surround - YouTube
but additional carry out the re-manufacturing (re-build) the voice coil and cone/diaphragm) like
Meyer Repair Service: Fender Speakers
but specialized to this transducer model from MS3.10.
Perhaps in Great Britain such a company exist.
I attach photos of the Mordaunt Short branded version of the driver for comparison.
Dimensions: 150mm corner to corner, 130mm side to side, 60 mm deep.
It would be difficult to suggest a modern replacement without knowing the full specifications of the original MS unit. Originals are available at auction in the UK.
https://www.ebay.co.uk/i/1241849183...MIstKnr57_6gIVGLd3Ch2mdQrTEAQYAyABEgI01fD_BwE
Dimensions: 150mm corner to corner, 130mm side to side, 60 mm deep.
It would be difficult to suggest a modern replacement without knowing the full specifications of the original MS unit. Originals are available at auction in the UK.
https://www.ebay.co.uk/i/1241849183...MIstKnr57_6gIVGLd3Ch2mdQrTEAQYAyABEgI01fD_BwE
